Once you are satisfied with where your images lie within the software workspace, you are ready to send the job to be laser cut/engraved.

To ensure that your object are in fact in the correct spot to cut/engrave, you will run a perimeter test. On the tool bar select run perimeter.
Watch as the laser head moved around the cardboard. Ensure that it is following in the right spot. If it is not, you will need to adjust the images on the software workspace.
If you are satisfied with the perimeter test, select stop.
You are ready to start the job. Select start on the tool bar.
A job preview will appear. On the left side, you will see the object panel. This will show you the order in which the laser will cut/engrave. You can move them around to set them up into a different order. In our case we will engrave the logo and then cut out the key chain.

**Troubleshoot**
	If you are engraving and cutting onto a material, you will want to put the engrave action first. If you put cut first, it may fall through the remaining material and move the laser slightly out of focus.

Print preview for the key chain example

Select send to the cutter.
The software will send the job over to the laser cutter.
Go to the laser cutter, and you will notice that a system check screen has popped up on the touch screen.
You are required to manually check each of the boxes to ensure that all of the safety features are engaged.

System Check

Dremel touch screen with the safety settings

Water cooling - An icon will highlight if the water cooler is connected. Ensure that the icon is highlighted green.
Air assist - An icon will highlight when you turn on the BOFA air filter. Ensure that the icon is highlighted green.
Vent fan - An icon will highlight if the vent fan is connected. Ensure that the icon is highlighted green. If it is red, flip up the green button on the back of the BOFA.
Lid - An icon will appear when the lid is closed properly. Ensure that the icon is highlighted green.
Laser head adjusted - Select the button when you have adjusted the head.
Material is laserable - Select the button if the material is safe to use.
I will remain at my laser - Select the button to ensure that you will watch as the laser cuts, to take action quickly is something goes wrong.
Press the button twice to start the job.

70%